Candy Cabinet Stools?

[markedkiller78]

Check the email address

Eh? New sideline

[Devil Soundwave]

Locking castors to stop it from slowly edging backwards as you play.

[cools]

Locking castors to stop it from slowly edging backwards as you play.

I tend to move around a lot anyway

Still hunting benches the right size

[kernow]

Check the email address

Eh? New sideline

[gargoyle67]

Still hunting benches the right size

Good luck, I've looked everywhere and can't find a decent one, I thought you didn't want a bench when I PM'ed you about rklok's benches

[cools]

Can't make up my mind.

[Devil Soundwave]

Contrary Cools.

[cools]

At this rate I'll be importing benches from Japan. I seem to recall they weren't the right size either, though. Knowing where from would be a start

[Devil Soundwave]

I believe River Service can get all this ****. Is it the Taito ones you want?

[cools]

No

[cools]

http://www.amazon.co.uk/Master-Billiard ... 813&sr=1-1"

Now we're getting close!

EDIT: After more thought, these are perfect. Ordered.

[gargoyle67]

WoW nice find mr cools, Wonder if their relatively new as I could find nothing even close when I looked I'll prob go for one of these
Edit**ordered

[cools]

Out of all the places to find arcade chairs, Amazon Marketplace.

Garg, I'm praying they're absolutely perfect for a Pony The height is the clincher - taking into account the seat pad squashing they should seat me at the same height as my chair. And they can be tucked under the CP when not in use!

[emphatic]

So, Ponys CP is higher than a TAITO made cab then? Because I've found that 40 cm height is optimal.

[cools]

Yes. The base of a Pony CP is about 61cm from the ground.

[gargoyle67]

Yes I was thinking the same thing looks Perfect for my Pony but I don't think it would suit my E3

[cools]

I have two on the way. Fingers crossed or that's an expensive screw up.

[gargoyle67]

Duno you could spend more ££££ and get the bottoms cut and re-welded, Don't think it would do the chrome finish any favors though
Should be ok though, Measurements look ok
Been an expensive month for us mate eh

[cools]

Cut and shut is no big deal, I have friends that can do that. Rechroming would be the expensive part. Fingers crossed though, I'm sure they'll be fine.

[cools]

Just had a response from River Service. They do the Taito "couple" chair (bench), as well as the Taito stools. The bench is height adjustable from 460-680mm, and the stools are 460mm high.