Sanwa PM1723C, loses V-hold when warm

For monitor related issues
Post Reply
User avatar
frsj8112
Posts: 62
Joined: April 11th, 2012, 6:06 pm
Location: Sweden
eBay: frsj8112

Sanwa PM1723C, loses V-hold when warm

Post by frsj8112 » October 7th, 2019, 6:29 am

Hi, I'm working on a Sanwa PM1723C which loses V-hold when it has been running about 20 minutes.

It all starts out ok, but after 5-10 minutes the image start to twitch a bit. And after 15 minutes the image starts to roll vertically.
After 20 minutes it rolls so fast that I cant distinguish any graphics on screen.

I've checked all solder joints around the HA11235 sync IC.
I've replaced the V-hold pot
All caps have been replaced.
I've also socketed the HA11235 sync IC and replaced it with a known working one.
No difference at all.

Any pointers at what to look for?
I'm going to buy one of those air-in-a-can so that I can flip it upside down and shoot some ice cold air onto some areas of the chassis handling vertical sync.

I attached the schematics for this chassis as well.
Thanks
Attachments
pm1723c.jpg

User avatar
grantspain
Tech Head
Posts: 4496
Joined: August 17th, 2008, 4:23 pm
Location: down south

Re: Sanwa PM1723C, loses V-hold when warm

Post by grantspain » October 7th, 2019, 9:52 am

could be a diode or transistor breaking down, is it in the sync or hold circuit is the question

Post Reply