29Z21 compatibility

For monitor related issues
Forum rules
ArcadeOtaku forum introduction & rules
Post Reply
User avatar
sugar4salt
Posts: 15
Joined: March 27th, 2017, 5:24 am
Location: South Korea
eBay: sugar4salt

29Z21 compatibility

Post by sugar4salt » December 26th, 2018, 2:14 am

Hi. I recently purchased a Sega 29Z21. I purchased it because it has very slight burn and its getting more and more difficult to get decent 29inch monitor these days. Anyhow, this was first time I faced this 29Z21 model and attached chasis has lack of pots compare to ms9-29.
Is it possible to swap with ms9-29 chasis? Would this be full compatible?


Regards

User avatar
grantspain
Tech Head
Posts: 4341
Joined: August 17th, 2008, 4:23 pm
Location: down south

Re: 29Z21 compatibility

Post by grantspain » December 26th, 2018, 9:13 am

yes works perfectly, you need to make an adapter for the deflection yoke as the sanwa is 4 pin and the ms9 is 2 pin + 2 pin and the vertical header is a smaller gauge
the rgb and manual degauss connector are also different

User avatar
sugar4salt
Posts: 15
Joined: March 27th, 2017, 5:24 am
Location: South Korea
eBay: sugar4salt

Re: 29Z21 compatibility

Post by sugar4salt » December 27th, 2018, 6:38 am

grantspain wrote:
December 26th, 2018, 9:13 am
yes works perfectly, you need to make an adapter for the deflection yoke as the sanwa is 4 pin and the ms9 is 2 pin + 2 pin and the vertical header is a smaller gauge
the rgb and manual degauss connector are also different
Thank you~
I will try that later~

Post Reply