Page 1 of 1

Sega Aero City marquee holder - measurements needed

Posted: October 21st, 2019, 11:51 am
by ckong
The Sega Aero city is quite a popular candy cab and I would like to reproduce the marquee holder for both the 'Japanese' Aero and the Aero with the different marquee holder which was produced for the European market. I don't have the marquee holders at hand, but maybe someone could take some measurements?

This is the info that I need for the 'Japanese' marquee holder (red lines A - J):

Aero City (Jap. Style) Needed measurements.PNG

And this for the 'Europese' marquee holder:

Aero City (Euro Style) Needed measurements.PNG

Please notice that A should be measured between the green guide lines. The measurements D through H are most important and should be accurate. And the measurements involving the holes should be measured from the center of the holes. And what is the diameter of the bottom holes (I don't know if the original marquee holder has holes behind the top metal clips, but I will use M4 bolts instead of the clips). If possible I would like measurements in mm's. :)

I will make the marquee holders with the beveled edge, like the original marquee holders have too.

Thx in advance.

Re: Sega Aero City marquee holder - measurements needed

Posted: October 21st, 2019, 12:20 pm
by FrancoB
I'm back home again a week on Wednesday (30th Oct). If you can wait until then I can create .dfxs of both of them for you.

Re: Sega Aero City marquee holder - measurements needed

Posted: October 21st, 2019, 10:34 pm
by ckong
FrancoB wrote:
October 21st, 2019, 12:20 MP
I'm back home again a week on Wednesday (30th Oct). If you can wait until then I can create .dfxs of both of them for you.
8-) :thumbup: