Page 1 of 1

HotD2 DLX: Buttons not working after re-wiring

Posted: March 30th, 2015, 7:25 pm
by meyerli
A while ago I got an incomplete House of the Dead 2 DLX with the shotguns of the HotD3. They use the same lightgun sensor.

After I found some missing parts (e.g. gun sensor board) I've done all the cabling between guns/buttons and the Naomi board.
Unfortunately none of the Buttons is working (gun triggers, start buttons including light, service button, volume control, etc). Aiming works fine.

So my first guess was something with the USB connection. Therefor I've tested the game with another Naomi board but could not find an issue. Another Naomi catridge with the HotD board was ok in another cab.

Anybody with a good hint what the cause could be or what would be useful to test as well?

If someone is interested here is a manual which contains the wiring diagram at the end:
http://tamdb.net/v2/index.php?action=do ... ;down=4575"

Re: HotD2 DLX: Buttons not working after re-wiring

Posted: March 30th, 2015, 7:38 pm
by andygeezer
Missing the loop pin connector on the 60pin jst ra connector??

Loops from pin 1 to 3 to enable active i/o.

Re: HotD2 DLX: Buttons not working after re-wiring

Posted: March 31st, 2015, 8:52 am
by meyerli
Thanks Andy.
Yes, it is connected.

Edit:
There was a Connection issue between 1 and 3... this is now fixed. Thanks again :)